成人性生交大片免费看vrv66,久久精品亚洲成在人线av麻豆,成人色网站免费观看

TranslationMobile

理論公式

"theoretical" in Chinese : adj. 1.理論(上)的，學理上的 (opp. app ...
"formula" in Chinese : n. (pl. formulas, -lae ) 1.公 ...
"formula for theoretical gravity" in Chinese : 理論重力公式
"theoretical formula in smoothing" in Chinese : 修勻的理論公式
"theoretical" in Chinese : adj. 1.理論(上)的，學理上的 (opp. applied)。 2.假 ...
"by formula" in Chinese : 按公式
"formula" in Chinese : n. (pl. formulas, -lae ) 1.公式，程式；定則，方案 ...
"the formula" in Chinese : 魔頭對魔頭
"air， theoretical" in Chinese : 理論空氣量
"information-theoretical" in Chinese : 信息論的
"potential theoretical" in Chinese : 位勢論的
"set theoretical" in Chinese : 集論的
"theoretical dry" in Chinese : 絕對干燥的
"theoretical abstraction" in Chinese : 理論抽象
"theoretical acoustics" in Chinese : 理論聲學

Examples

Deduction of the theoretical formula of the bending center and its application
彎曲中心理論公式的推導和應用
In addition , a theoretical formula of the system performance was derived
另外還導出了單穩態系統性能的理論公式。
Making use of the amendatory " truss + arch " theory , the theoretical formula of the shear resistanc
目明，理論抗剪公式是偏于安全的。
We deduced the basic theoretical formula for analyse piezoelectrics and acoustic fluid using fem
推導了使用有限元分析壓電體和聲學流體的基本理論公式。
Making use of the theoretical formula of shear resistance , the shear mechanism of general beams is analyzed
利用理論抗剪公式，分析了一般梁構件的抗剪機理。
The theory of the block element method is systematically presented here and its relative theoretical formulas are deduced . 2
系統地介紹了塊體單元法的理論，進行了相關的理論公式的推導。
Based on the heat conduction theory , the fea theoretical formulas of temperature field and thermal stress are deduced in this paper
本論文從熱傳導理論出發，推導出溫度場和溫度應力的有限單元法理論公式。
Theoretical formulas described the relations between properties and composition distribution of the flier - plates was also derived
通過理論推導，分別建立起了相關性能參數與復合體系組成分布之間的數學表達式。
Moreover , the theoretical formula were applied in combination of practical example , with the temperature distribution along the radial direction in a transient state proposed
并結合算例給出了在短時超高溫條件下煙囪筒身沿徑向的瞬態溫度分布。
The results of finite element model and theoretical formula are proved to be in good agreement with the experimental results
在基于現行規范的基礎上提出了組合梁跨中撓度的建議計算公式把有限元模型和建議公式的計算結果與試驗結果進行比較，三者吻合良好。